Shijiazhuang Lock Joint Explains Various Preservation Methods of Impactor

Classification:

Company News

Release time:

2019-08-19

【Summary Description】 Shijiazhuang Lock Joint Explains Various Preservation Methods of Impactor

锁接头

1.For short-term storage, follow these steps:

First, blow the air to remove the water from the impactor;

Second, fill the upper joint part1 litre of end oil;

Third,(Shijiazhuang lock joint)Open the wind, blowAbout 10 seconds, so that the internal parts of the impactor can be fully lubricated;

Fourth, as with the drill pipe, cover the upper and lower joints with rubber caps respectively;

Fifth, place the impactor horizontally in a dry environment.

2.Long-term preservation, slightly different:

First, blow the air to remove the moisture from the impactor;

Second, loosen the upper joint and the lower joint, and disassemble the impactor;

Third,(Shijiazhuang lock joint)Check and wipe all internal parts, it is best to do this work in a clean room;

Fourth, with the appropriate lubricating oil, moderate lubrication of all parts;

Fifth, assemble the impactor and cover the upper and lower joints with rubber covers;

Sixth, place the impactor horizontally in a dry environment.

3.To re-enable the impactor, three steps are required:

First, disassemble the impactor and detect all internal parts. If it is found that the surface of some parts is oxidized, it is necessary to properly polish the oxidized part with sandpaper.

If it is not tested and put into use directly, it is likely to cause premature failure of the impactor.

Second,(Shijiazhuang lock joint)Clean all parts, wipe them clean and lubricate them.

Third, the cleaned and lubricated parts are assembled into an impactor and can be put into use.

锁接头

Key words:

weilida drill