1.Outside flat drill pipeIn terms of location, if it is a well used by one's own family, it is generally chosen in the white tiger side of the residence. If it is a public well in a village, don't be too far away from the village, which is easy to cause inconvenience in life. Generally, wells are not drilled in the four directions of Zi (due north), Noon (due south), Mao (due east) and You (due west), which are often slightly offset.Only 15 degrees can be used;

2. The land around the well should be clean, and there should be no garbage dumps or toilets around to pollute the well water. We should not drill wells for drinking water in lead heavy metal mines or sulfur hot springs, because it will endanger human health. Therefore, before drilling the well, it is better to invite specialized agencies to carry out water quality testing to ensure the purity of the water source;

3. With the progress of science and technology, modern rural wells are generally motor wells. However, in some remote mountainous areas, there are no suitable conditions, and the traditional windlass well is still being drilled. At this time, attention should be paid to the fact that the wellhead must not be parallel to the ground. Masonry should be piled up around the wellhead and higher than the ground. It is even better to set a cover at the wellhead, so that dirty things can be prevented from falling into the well and polluting the well water regardless of wind and rain. It is also beneficial to people, protect your own safety.

Drilling is a large project, drilling team to complete the whole project needs sufficient time, need a lot of financial resources and manpower, therefore, before drilling well to make full preparations, but also to choose a good location, a good location, can avoid a lot of trouble,Outside flat drill pipeTo sum up for you, how to choose a good drilling location.

4. The geological drilling team recommends that everyone avoid underground stones. The underground situation is complex and changeable. The shallow underground strata are layered within a few kilometers, and there will also be geological phenomena such as folds, fractures, basement uplifts, depressions, etc. If it is not a fixed location, it is difficult to use the underground conditions of a certain area to explain the underground geological conditions of a specific location. A multi-faceted analysis of the lot is required.

5. The location of the well is mostly suburban or smaller towns or rural areas. Because the sewage or drainage facilities in these places are not sound enough, it is easy to pollute the wells. Some suburban or village areas have farmland or vegetable plots, and today's crops have to apply chemical fertilizers, which are not easy to decompose in the land and will seep into groundwater with the water source, so stay away from the polluted area. If there is farmland or vegetable fields around, it is impossible to avoid it. It is recommended to drill the well deeper. The surrounding of the well shall be treated with anti-seepage treatment, such as forming isolation with hollow cement column.

6. If you are drilling a deep water well, it is recommended.Outside flat drill pipeDo hydrogeophysical prospecting before drilling(that is, geophysical prospecting for water), we can find out the distribution law of local strata, underground structural faults and fissures, estimate the amount of water, and greatly improve the probability of successful water discharge.